What do i need to change motherboard11/26/2022 ![]() ![]() It’s easier to do at this stage of the process. Wipe your forehead, and we’ll proceed with the second part of the operation.īefore placing the new board into the case, install the memory. Just use the pliers to remove them, and the board should come free. The board could be attached to your case with small screws or with small, cone-shaped plastic connectors called standoffs. Doing so may require the use of needle-nosed pliers, or it may not. If you do, just repeat the above steps for labeling, and you’ll be fine.įinally, you’re ready to remove the motherboard physically. I say possible because not everyone will have to do this. It’s quite possible that you’ll be required to remove the power supply and hard drives before proceeding. You’ll want to lay them flat on a clean, dry towel for the duration of this part of the operation.Īnd now for the main event-almost. Now, remove the components, including plug-in cards and memory. Make a mental note of where everything goes. The next thing to do is to disconnect any cables that are attached to your motherboard. It’s a harmless way to prep yourself before getting your hands any further into your patient. Touching the power supply’s case will discharge any static. So, unless you have one of those fancy grounding straps handy-and I never do-touch your power supply. Static electricity can hit you like a stealth bomber-by the time you discover it was anywhere near you, the damage has already been done. Now is a good time for a quick tip: Since all of the components inside the case are static-sensitive, it’s a good idea to discharge any stored electrical charges. You can indicate right on the cable where it should be attached once the surgery is over. Tear off some short pieces and label the existing cables. Grab some masking tape and a felt-tip pen. Here’s a tip in case you’re not 100 percent comfortable with the replacement process. Once that’s done, go ahead and remove the old case. But before you remove the old motherboard, you’ll need to disconnect all of your peripherals. This is a good time to remember what some wise, ancient sage once said: Anytime you attempt to make a change to your system-especially one as major as this-always, always perform a fresh backup. ![]() After all, it’s all about performance, isn’t it? So, go ahead and add that new hard drive, extra add-in cards, DVD, and, above all else, a new power supply. And inside this new machine, you’ll probably want to add all sorts of new and improved gadgets that increase performance. Of course, when you do that, you’re basically building a new machine. If the new motherboard doesn’t fit the old case, you can always buy a new case. The Tim Taylor Tool Time Tune-up Temptation Just make sure that you have some way of securing the smaller board to the case. That doesn’t mean you can’t fit one of the new, smaller boards into a larger, old case. To keep this job simple, it’s always a good idea to get a motherboard with the same dimensions or form factor as the one you’re replacing. Motherboards come in several different form factors. The dimensions matter a great deal when you’re considering a new board. ![]() Also, if you want to use your existing memory, you’ll want to make sure that the new board supports the type you’re using now. You’ll need the above information, particularly the dimensions, when you go shopping for a new board. Types of peripherals and ports to which they attach.Dimensions of your current case and motherboard.There are a few things that you will need to know before actually replacing your motherboard. So, before you begin, let’s consider what you need to know. In a way, it’s major surgery for your PC. It’s probably the closest any of us will come to performing major surgery. In order to replace the motherboard, you’re going to have to get your hands dirty. Access to new features that you can only get via a new chip set, like a faster system bus and new peripheral controllers.Jumping from one processor type to another, like from Socket 7 to Slot One.Here are the ones that stand out in my mind-outside of just for fun: After all, why replace your motherboard-which may run you a couple hundred bucks-when you can replace your entire machine for just a couple of Ben Franklins more? Well, believe it or not, I can’t think of any reason except for the fun of it.īut of course, there are reasons to upgrade. With the decline in PC prices, replacing your motherboard has become harder and harder to justify. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |